Wingscapes BirdCam Pro User Manual download pdf (Page 5)

Quick Start Guide

Use the steps below as a guide to quickly set up your camera so it will function using the

factory default settings.

STEP 1

Open camera cover. Press the Battery Chamber Release button. Install 6 C-cell alkaline

batteries. Recommended for use: Duracell

or Energizer

batteries. Reinsert the Battery

Chamber into the camera until you hear an audible click.

Rechargeable batteries are not recommended.

Do not use lithium batteries.

STEP 2

Insert SD Memory Card (label side up) until you hear an audible click. Camera will not

operate without SD Card. Slide the power switch to ON. Move the Rotary Dial switch to

the SETUP position and set the time and date by pressing the LEFT button until TIME/

DATE appear on screen. Press OK to begin entering the Time and Date, using +/- buttons

to adjust the values and LEFT/RIGHT to move between ﬁelds.

STEP 3

Mount Camera in desired location using a mounting

strap or other accessories offered by Wingscapes

(visit www.wingscapes.com for more information on

mounting accessories). Switch the camera to Laser

Aim by sliding the power switch to the corresponding

position. Aim camera using laser projection to

determine target location.

STEP 4

Slide the power switch to the ON position. Turn the

Rotary Dial to the mode of operation desired and

close the cover. The camera will operate using default

settings for the respective mode selected. You may

also customize the settings if desired. Press the Right

(>) button to begin ﬁlming.

Page 5

BirdCam PRO User Guide

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Wingscapes BirdCam Pro User Manual Page 5